Following the drilling of a pipe which is embedded in it, therefore not visible, for the installation of a frame or an element on the wall of one or to install a threshold bar or the installation of a bowl drilled on the ground to be able to install the toilet fixings, make sure that a pipe does not pass through the floor (if you have underfloor heating).
It is then necessary to have a water leak detector to be able to locate it to repair this water leak, in certain cases, it is necessary to use a water leak detection device.
The company specializes in water leak detection, we take care of the detection and repair as well as a detailed report to be sent to your insurance to have support for the search for water leaks. ‘water.
How to repair a water leak at a fitting?
If the water leak comes from a brass fitting, how do Drainage Maintenance Services repair it? First of all, we must identify the general water shut-off valve in your apartment, purge the pipe by performing a reverse air call from a tap by opening it on the reverse side (if the leak is the water comes from cold water, we will open the hot water tap to perform a draft or from a braided steel water supply hose.
Then we disassemble the nuts that hold this fitting, we will shape the beaten collars, replace the fiber or rubber seals to replace the 12/17 or 15/21 brass fitting for the bathroom part and 20/27 for the water heater part or water meter for the general sanitary cold water supply of the house.
The consumption of a leaking toilet flush represents an average of 620 liters of water wasted unnecessarily which would flow into the pipes through the toilet bowl, i.e. the consumption of a family of 4 at home.
A sink faucet leaking from the base of a leaking faucet head seal, which would then flow into the sink or sanitary facility concerned. An outdoor garden pipe that would have broken due to an outdoor frost due to an outdoor temperature below 0 degrees, which is poorly protected by insulation, or a pipe built into the garden would have been damaged by the roots of a tree.
Requiring then a search for water leaks in built-in or directly the replacement of the section of the damaged piping which is often made of Polyethylene of the generic PE cycle of black color with blue stripe for the sanitary cold water network, black color with yellow stripe for the gas network.
